Rockwell RK7240.1 13 Amp 10-Inch Table Saw with Stand
Rockwell RK7240.1 Shop Series 13 Amp 10-Inch Table Saw with Stand
- Lightweight and easy to transport
- Large safety on/off switch for enhanced control and operator safety
- Reinforced cast aluminum table top for greater stability and precision
- Quick Lock rip fence for quick and easy use with larger stock pieces
- Integrated dust collection port for easy vac attachment
02/21/2012
23:56
Rockwell RK 7240,
This is truly a portable as far as weight is concern. The only deficiencies I see in this model is the rather flimsy blade height adjusting wheel, and the absence of a zero clearance blade plate option, which plate is also shimmed rather poorly because they are loose and rather not easy to reposition once you remove the plate to change blades. Other than that is a fine little machine with a powerful motor and nice stand. For the money you can’t go wrong, it’ll do the same job as other much more expensive 10″ saws. It’s kind of a Deja VU to the old Makita little “Green” portable that I used to own, and was looking for when I came across this one.
Was this review helpful to you?
|02/22/2012
00:22
Believe the reviews: this saw is terrible,
While the reviews were less than sterling, I didn’t think it could be that bad. My mistake.
I ordered this saw as a gift for my son, who lives with his family on the other side of the country. He has a limited amount of space and limited need for a table saw. But, during a visit, we’re building some shelving for their home and thought it would be helpful to have a saw.
This was NOT the right choice. Example: the included miter gauge is made of cheap plastic, will not hold a 90 degree angle.
Can’t buy an aftermarket replacement, since guide slot is non-standard 5/8-inch. The fence is cheap and not at all accurate. Cheap plastic handles fall off the bevel/height adjustment spinners.
I’m surprised that Amazon would actually carry something as poorly made as this product.
Was this review helpful to you?
|02/22/2012
00:34
Seen better,
Cannot put a dato blade on it. Shaft is too short. Saw dust comes out the face plate. Miter groove is only 5/8 and shallow.
Was this review helpful to you?
|